An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on cleaning up hard drive, erasing hard drives, degaussing equipment, and degaussing services, see also: erase hard drive computer free tape head cleaner hard drive cleaning software erase access denied files completely wipe hard drive free hard drive wipeout how to clean up your hard drive securing access data without user-level security wipe out a hard drive free hard drive clean download windows 2000 hard disk clean old compressed files slow windows 3.1 disk erase clean program from hard drive completely how to wipe your hard drive how to delete unused data in ms systems config can a magnet erase my hard drive how to delete unwanted files from hard drive erase unix hard drive data completely wipe hard drive delete files from hard drive how to delete hard drive free clean hard drive data protection and security erase hard drive reinstall windows me deep clean hard drive completely erase a: floppy disk completey erase harddrive mds-4 degausser & prices completely erase a: floppy disk hard drive erase program pc hard disk cleaner how to delete unused data in ms systems config hard drive cleaning software free clean hard drive hard disk data wipe tools how do i delete all files on my hard drive bulk audio tape eraser how do i delete my hard drive erase disk hard disk clean up software

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on cleaning up hard drive, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: