An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on data warehouse control and security, erasing hard drives, degaussing equipment, and degaussing services, see also: homemade degausing coil erase first sector on hard drive wipe the hard drive erase access denied files mbi degaus data protection and security free hard drive wipe hard disk clean up software free free hard drive clean delete your hard drive home security equipment data degauss goldschmidt chemical co 16 bit hard disk cleaner grid data security clean hard drive completely erase files in the restore directory hard drive wipe xp how to clean out hard drive on computer hard drive scrub dell d266 degaussing clean files security issues in data facility management media cleaner profiles download free hard drive clean download clean program from hard drive completely erase cd freeware free clean hard drive how do i wipe my hard drive clean how to delete unused data in ms systems config clean hard drive reinstall windows 98 free clean hard drive free hard disk erase software degauss video security data guard technology will mother board failure erase data on hard disk homemade tv degausser script to erase media from tape free hard drive wipe permanently delete files from hard drive windows 3.1 disk erase

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on data warehouse control and security, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: