An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on delete your hard drive, erasing hard drives, degaussing equipment, and degaussing services, see also: hard drive cleaning tips hard disk erase sony trinitron degauss circut how do i delete all files on my hard drive data transmission security degausing coil construction clean install of windows instructions format hard drive erase a hard drive steps expo dry erase cleaner material safety data sheet degauss video securities data corporation how to wipe your hard drive how to delete unwanted files from hard drive erase media from 8mm tape the easy way degausing coil construction erase cd freeware degaus what can i do to clean up my hard drive data link layer security homeland security data bases cd-rw erase selling computer erase disk disc cleaner video tape eraser script to erase media from tape honeywell media air cleaner how to erase a cd r erase unix hard drive data hard drive erase program how do magnet erase tape memory can a magnet erase my hard drive why can't i erase data off my cd-rw disc driver to erase rewrite cd secure erase hard drive grid data security degaussing color monitors clean hard disk destroy data and hard drive and emergency degauss thermistor what will happen if i erase my hard drive

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on delete your hard drive, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: