An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on free hard disk erase software, erasing hard drives, degaussing equipment, and degaussing services, see also: driver to erase rewrite cd hard drive erase program key to installing an upgrade cd in a clean hard drive mobile data security sony trinitron degauss circut m100 erase all data delete hard drive partition erase access denied files degaussing facilities format hard drive erase government data clean erase internet files security issues in data facility management windows 2000 hard disk clean old compressed files slow mds-4 degausser & prices info about data security how to delete unused data in ms systems config free hard drive wipe offshore data security how do i completely erase a hard drive erase first sector on hard drive wipe out a hard drive data security policies how to clean a hard drive more data less security hard drive scrub honeywell media air cleaner how do i completely erase a hard drive selling computer erase disk computer virus erases data on hard drive why can't i erase data off my cd-rw disc hard drive wipeout degauser coil clean a hard drive clean hard drives completey erase harddrive erase files software clean program from hard drive completely clean hard drive xp how do i delete all files on my hard drive sdlt tape eraser

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on free hard disk erase software, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: