An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on hard disk data wipe tools, erasing hard drives, degaussing equipment, and degaussing services, see also: destroy data and hard drive erase hard drive microsoft clean install of windows instructions format hard drive mbi degaus completely wipe hard drive erase hard drive on mac securely erase hard disk m100 erase all data free clean hard drive lost data in windows security event log degauss equipment campus data and security m100 erase all data politician wipes hard drive how do i delete all files on my hard drive data protection and security degauss thermistor best media cleaner settings computer virus erases data on hard drive clean hard drive xp how to erase hard drive in dos ships degaussing principle how to delete unwanted files from hard drive erase data hard drive degauss monitor erase cd erase disk dell d266 degaussing maryland state data security free hard drive wipe r.s. andrews high efficiency media retrofit air cleaner wipe hard drive software wipe hard drive software destroy data and hard drive hard drive wipe xp how to clean up your hard drive how to wipeout a hard drive key to installing an upgrade cd in a clean hard drive hard disk erase how do i completely erase a hard drive

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on hard disk data wipe tools, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: