An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on how do i wipe my hard drive clean, erasing hard drives, degaussing equipment, and degaussing services, see also: expo dry erase cleaner material safety data sheet cd-rw erase how to delete unused data in ms systems config how to erase hard drive in dos mds-4 degausser & prices how do i delete all files on my hard drive ships degaussing principle unix tool erase disk cleaning up hard drive v91m hd hard disk drive degausser clean files instant hard disk eraser how do i delete my hard drive security issues in data facility management totally erasing a hard drive ptc degaussing free hard disk erase software dell d266 degaussing hard disk clean up software erase hard drive reinstall windows me clean hard drives unix tool erase disk windows 3.1 disk erase clean hard drives erase media from 8mm tape the easy way how degaussing works definition of data cleaning how to delete hard drive r.s. andrews high efficiency media retrofit air cleaner wipe hard drive with cipher.exe how do i delete all files on my hard drive completely erase hard drive wipe out a hard drive more data less security erase hard drive on mac why can't i erase data off my cd-rw disc erase first sector on hard drive erase hard disk mac keyboard command delete data miner erase media from 8mm tape the easy way

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on how do i wipe my hard drive clean, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: