An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on how to delete unwanted files from hard drive, erasing hard drives, degaussing equipment, and degaussing services, see also: how to erase a cd free hard drive clean download wipe the hard drive how to delete unused data in ms systems config how do i completely erase a hard drive script to erase media from tape free hard disk erase software unix and wipe disk and erase all how do i wipe my hard drive clean unix and wipe disk and erase all video tape eraser erase hard drive on mac erase hard drive reinstall windows me delete hard drive partition homemade degausing coil clean hard drive xp erase a hard drive permanently security issues in data facility management delete partitions on hard drive how to clean up your hard drive how to delete unused data in ms systems config how do i wipe my hard drive clean offshore data security how to delete unwanted files from hard drive how do i erase a hard drive securing access data without user-level security dell d266 degaussing how to wipeout a hard drive definition of data cleaning software to clean up hard drive honeywell media air cleaner securely erase hard disk why can't i erase data off my cd-rw disc clean hard drive cookies will mother board failure erase data on hard disk more data less security dss files erase completely wipe hard drive erase data on hard drive more data less security

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on how to delete unwanted files from hard drive, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: