An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on how to erase hard drive in dos, erasing hard drives, degaussing equipment, and degaussing services, see also: hard drive erase program how to clean a hard drive free clean hard drive erase disk erase aol cd how to clean up your hard drive to make more room how do i completely erase a hard drive ptc degaussing completely wipe hard drive free erase a hard drive permanently best media cleaner settings expo dry erase cleaner material safety data sheet free hard drive clean download wipe out a hard drive clean hard drives how do i completely erase a hard drive destroy data and hard drive and emergency recuperate erase files erase free space on hard drive degaussing color monitors how to delete unused data in ms systems config how to clean out hard drive on computer how to erase files on a audio cd wipe the hard drive completey erase harddrive computer virus erases data on hard drive will mother board failure erase data on hard disk homemade degausing coil how to erase files on a audio cd why can't i erase data off my cd-rw disc how to delete hard drive will mother board failure erase data on hard disk delete your hard drive data warehouse control and security erase disk erase disk data transmission security securing access data without user-level security bulk audio tape eraser erase unix hard drive data

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on how to erase hard drive in dos, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: