An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on unix tool erase disk, erasing hard drives, degaussing equipment, and degaussing services, see also: software to erase hidden files hard disk data wipe tools data link layer security dell d266 degaussing pc hard disk cleaner clean program from hard drive completely home security equipment data hard drive clean sweep can a magnet erase my hard drive delete hard drive to reinstall windows 98se securing access data without user-level security hard drive clean sweep erase first sector on hard drive rsa data security hard disk data wipe tools how to degauss your television degauss monitor delete partitions on hard drive expo dry erase cleaner material safety data sheet grid data security degausing coil construction erase files software free hard drive wipe how to wipe hard drive homemade tv degausser government data security color codes definition of data cleaning delete your hard drive key to installing an upgrade cd in a clean hard drive instant hard disk eraser expo dry erase cleaner material safety data sheet free hard drive wipe buy tv degausser instant hard disk eraser data transmission security erase aol cd degausing coil construction data center security partitions clean out hard drive and reinstall os clean files

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on unix tool erase disk, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: